User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
24 PM45 and PM45c Accessory User Guide
1. Turn off the printer and disconnect the power cord.
2. Remove the media cover (See page 2).
3. Remove the electronics cover (See page 4).
Installing RFID Antenna
1. Turn the printhead lever counterclockwise to raise the printhead.
2. Remove the tear bar.
Caution: Follow standard ESD guidelines to avoid damaging the
equipment.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.
(x3)
(x3)