User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
26 PM45 and PM45c Accessory User Guide
guide assembly and inside wall of the printer base.
6. Replace and secure the tear bar and platen roller.
Install the RFID Board Assembly
1. On the back of the printer, remove the two screws that secure the cover plate to
the printer, and remove the cover plate.
2. Attach the spacer screw to the center of the printer main board.