User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
30 PM45 and PM45c Accessory User Guide
Installing the Applicator Interface Board
Follow the procedure to physically install the Applicator Interface Board in the
PM45 printer.
Note: This procedure applies to both the PM45 and PM45c printers. For simplicity, the
PM45 is depicted in the illustrations.
1. Turn off the printer and disconnect the power cord.
2. Remove the media cover. (See page 2).
3. Remove the electronics cover. (See page 4).
4. Remove the two screws on the back of printer securing the cover plate and
remove the cover plate.
Warning: The installation described in this section must only be
performed by an authorized service technician.
Honeywell assumes no responsibility for personal injury or
damage to the equipment if the installation is performed by an
unauthorized person.
Caution: Follow standard ESD guidelines to avoid damaging the
equipment.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.