User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
32 PM45 and PM45c Accessory User Guide
9. Insert the power cable J33 on the printer main board and connect the other
end J2 on the of the applicator board.
10. Put the electronics cover back on secure it with the 4 screws.
11. Put the media cover back on and secure it.
Interfacing
This option board contains 4 connectors for a Z-Style Port, an S-Style Port, an
External Power Port, and an External Error Port.
J33
J2
Port Description
Z-Style A D-Sub 15Pin receptacle connector.
S-Style A D Shaped SCSI 14Pin connector.
External Power A Mini-DIN 6Pin receptacle connector.
External Error A Mini-DIN 8Pin receptacle connector.