User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
56 PM45 and PM45c Accessory User Guide
Cutter Module
Cutter modules for PM45 and PM45c come with standard cutter module for non
adhesive labels and a cutter with adhesive resistant blades for adhesive labels.
The installation procedure is same for both models of cutter.
Installing Cutter Module for PM45 Printer
Use these instructions to install the cutter in the PM45 printer. You will find the
following items in the shipping box.
• Standard Cutter module with bracket
• 4 Torx screws and 4 washers
You will need a Torx screwdriver to install the cutter module.
To install the standard cutter module,
1. Remove the media cover. (See page 2)
2. Remove the front access door. (See page 5)
3. Remove the three screws that attach the tear bar to the printer and remove it.
Warning: The cutter must only be installed by an authorized service
technician.
Caution: Follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.