User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
60 PM45 and PM45c Accessory User Guide
5. Remove the three screws that attach the UI cover to the printer and open the
cover. Do not disconnect the UI cable as you lay the cover on its side.
6. Connect one end of the cutter cable to the main logic board.
7. Route the cutter cable through the printer and out behind the UI cover. Use the
two cable retainers to secure the cutter cable in place.