User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 75
8. Slide the Ticket guide retainer onto the media guide post and secure it in place
with the thumbscrew. Make sure it fits securely against the Ticket guide closest
to the outside of the printer.
9. Partially insert the upper media guide into the printer and reconnect the gap
sensor cable to the end of the upper media guide.
10. Insert the upper media guide all of the way back into the printer. Make sure the
plastic pins on the end of the upper media guide fit into the holes in the printer
frame and that the end of the upper media guide fits securely over the end of
the media post.