User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
94 PM45 and PM45c Accessory User Guide
Thermal Printhead
The thermal printhead for PM45 and PM45c printers are available in 203, 300,
406, 600 dpi. The installation procedure is same for both printer models.
Out of the Box
• Thermal printhead
Installation
1. Open the media cover.
2. Turn the printhead lever counterclockwise to raise the printhead.
3. Detach the magnetic pressure arm from the printhead bracket and disconnect
the two cables from the existing printhead as you remove it from the printer.