User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 43
Example:
• ON PORTOUT.RESET GOSUB nnn
Using External Applicator Signals
The printer responds to external applicator port signals differently, depending on
whether your application is using Fingerprint or Honeywell Direct Protocol.
Fingerprint and Applicator Signals
When you use Fingerprint, all in signals and the Data-ready out signal are
handled by Fingerprint. Other out signals are handled by firmware.
Feed
When the Feed in signal is received, the application moves to a specified subrou-
tine that feeds labels until the Feed in signal is de-asserted.
Example:
• 10 ON PORTIN.FEED GOSUB 200
...
200 FORMFEED
210 RETURN
Pause
When the Pause in signal is received, the application moves to a specified subrou-
tine that finishes the current print job and then places the printer in pause mode.
Example:
• 10 ON PORTIN.PAUSE GOSUB 90
...
90 pause printer
Startprint
When the Startprint signal is received, the application moves to a specified subrou-
tine that starts the print job. The Startprint signal must be preceded by the
dataready signal as seen in this example.
Example:
• 10 PORTOUT.DATAREADY on
20 ON PORTIN.STARTPRINT GOSUB 60
...
60 my print routine
70 PRINTFEED
80 RETURN