User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 67
Rotation Hanger
The rotation hanger enables consistent feeding of the media stock and also
includes low paper detection feature.
The rotation hanger accessory can be used for both PM45 and PM45c printer.
Out of the Box
• Oil-saturated felt washer
• Reflective wheel
• Metal rod
• Four 7/8-inch rotation core
• Spring
• Metal washer
• Torx screw
Installation
You will need the following tools to install the rotation hanger.
• T20 Torx screwdriver
• Small wrench
• Phillips screwdriver
To install the rotation hanger, you need to open the printer and physically install
the hanger in the printer.
You need to remove both the media cover and the electronics cover to install the
rotation hanger.
Warning: The rotation hanger must only be installed by an authorized
service technician.
Warning: Follow standard ESD guidelines to avoid damaging the
equipment you are servicing.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.