User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 33
Z-Style Port
Z-Style Port Pinouts
Pin Signal Type Description
1 Signal ground Ground configurable for internal or external source
2 +5VDC Power Voltage supply for external sensors. Configurable for
internal or external source.
3 Start print Input Pulse Mode - prints one and only one label whenever this
pin is pulled to ground. Signal must be de-asserted and
reasserted to print another label.
• Printing starts on HIGH to LOW transition if format is ready.
• De-assert this signal to HIGH to inhibit printing.
Level Mode - prints labels continuously when this pin is
pulled to ground. Printing is disabled when signal is de-
asserted. If a label is printing when de-asserted, printing
stops after the label is complete.
• Assert LOW to start printing if format is ready.
• De-assert HIGH when current label has finished printing.
Remains de-asserted while waiting for the next label to be
ready to print.