User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 79
Extendable Tray
The extendable ticket tray accessory is used to hold the printed boarding pass in
upward position and allow easy tear off at perforation.
The extendable tray is compatible only with PM45c printer.
Out of the Box
• Extendable tray
• Two #T20 Torx screw
• Two washers
Installation
You will need the following tools to install the accessory.
• Torx screw driver
• Small wrench
To install the extendable tray,
1. Remove the media cover. (See page 2)
2. Remove the front access door. (See page 5)
3. Carefully turn the printer on its side and align the extendable tray with the
holes on the base of the printer and attach it with the two torx screws and
washers.
(x2)