User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
86 PM45 and PM45c Accessory User Guide
Large Media Edge Arm Guide
The large media arm edge guide accessory prevents horizontal skewing of large
media rolls.
This accessory is compatible with PM45 printer.
Out of the Box
• Large media arm edge guide
Installation
You will require a Torx screw driver to install the accessory.
To install the large arm edge media guide,
1. Bring the arm edge guide to the far end of arm and turn 90 degrees clockwise
direction.
2. Insert the torx screw driver between the arm and guide and twist the screw
driver counter clockwise direction to remove the small arm guide.