User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
2 PM45 and PM45c Accessory User Guide
Set Up Printer for Installing Board/Accessories
You need to remove both the media cover and the electronics cover to install the
interface boards or accessories.
You will require the below tools to remove the media and electronics cover.
• #T20 Torx Screwdriver
• Small wrench.
Remove Media Cover
To remove the media cover for PM45 printer,
1. Open the media cover.
Full Batch Rewinder PM45
Large Media Edge Arm Guide PM45
Short Media Cover PM45c
Dome Media Cover PM45c
Thermal Printhead Both
Accessory
Compatible with
PM45/PM45c/Both
Caution: Read and review the warnings in this manual carefully before
connecting the printer.
Caution: Before you begin, turn off the printer and disconnect the power
cord and communication cables.