User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
10 PM45 and PM45c Accessory User Guide
7. Secure the optional board assembly to the spacer with a Torx screw.
8. Insert the USB cable into the J38 or J37 connector on the printer main board.
Then insert the other end into the J13 connector on the Industrial Interface
Board.
9. Fit the straps and circuits on the board to configure the type of serial
communication you want to use. For more details, see Serial Interface.
10. Put the cover back and secure it with the 4 screws.
J37
J13