User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 13
RS-422 Isolated, Full Duplex (reconfiguration required)
Note: The RS-422 circuit is available as a spare part.
Connector Configuration (RS-422 on “uart2”)
RS-422 Socket Pin of DB9 Signal Name Description
1 +5VDC External +5VDC max 600mA (automatic
switch off at overload, short-circuit protected)
provided strap is fitted on P3:2-3 which spoils
the galvanic isolation
2 +TXD +Transmit data
3 +RXD +Receive data
4 -
5 GNDE Ground
6 -
7 -RXD -Receive data
8 -TXD -Transmit data
9 -
1
2
3
6
4
5
7
8
9