User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 23
RFID Interface Board
This section describe how to install the RFID interface board and the connector
configuration.
Out of the Box
• One RFID interface board
• RFID antenna
• One antenna cable
• Two USB cables
• One spacer screw
• Two Torx screws
You will also need a #T10 and #T20 screwdriver and a small wrench.
Installation
To install the RFID module, you need to open the printer and physically install the
module in the printer.
Before you install the RFID module, you need to first install the RFID antenna.
• Installing RFID antenna
• Installing RFID interface board
Warning: The installation described in this section must be only
performed by an authorized service technician. Honeywell
assumes no responsibility for personal injury or damage to the
equipment if the installation is performed by an unauthorized
person.