User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
48 PM45 and PM45c Accessory User Guide
Message:
APPLICATOR PORT: Wait for signal.
Cause:
Running a PRINTFEED command blocks execution until a
startprint signal is received. The message appears when
execution has been blocked for a few seconds.
Message:
APPLICATOR PORT: Wait for reprint.
Cause:
Running a PRINTFEED -1,1 command blocks execution until a
reprint signal is received. The message appears when execution
has been blocked for a few seconds.