User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 81
Full Batch Rewinder
The full batch rewinder accessory can rewind a full batch of 8” media roll. The
accessory comes with a bottom extended enclosure, internal rewind mechanism
and a cut out base.
This accessory is compatible with PM45 printer.
Out of the Box
• Extended base rewinder
• Batch plate
• 3 Torx screws
Installation
You will need these tools to install the full batch rewinder.
• #T20 Torx screw
• Small wrench
To install the full batch rewinder,
1. Remove the media cover. (See page 2)
2. Remove the electronics cover. (See page 4)
3. Remove the front access door. (See page 5)
4. Remove the three screws that connect the tear bar to the printer and remove it.