User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 5
Remove Front Access Door
To remove the access door for PM45 printer,
1. Open the access door and lift it out and away from the printer.
To remove the access door for PM45c printer,
1. Open the access door, remove the T20 screw that attaches it to the printer and
slide it out and away from the printer.
For more information about available accessories, see the PM45 product page at
www.honeywellaidc.com. Contact your local sales representative for ordering
information.