User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
20 PM45 and PM45c Accessory User Guide
1. Turn off the printer and disconnect the power cord.
2. Remove the media cover (See page 2).
3. Remove the electronics cover (See page 4).
4. On the back of the printer, remove the two screws that secure the cover plate to
the printer, and remove the cover plate.
5. Insert the parallel port board into the printer, and secure the board with the two
screws you removed in Step 4.