User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
22 PM45 and PM45c Accessory User Guide
Parallel Interface
This section describes the signals on the connector of the IEEE 1284 interface
board.
Connector Configuration
The IEEE 1284 board has a standard 36pin IEEE 1284 B socket with the following
configuration.
Pin Signal Remark
1 DSTROBE
2 DATA0 +Transmit data
3 DATA1 +Receive data
4 DATA2
5 DATA3 Ground
6 DATA4
7 DATA5 -Receive data
8 DATA6 -Transmit data
9 DATA7
10 ACK
11 BUSY
12 PE
13 SELECT
14 AF
15 N/C Not Connected
16 GND
17 SCREEN
18 - External +5VDC max 500mA (automatic
switch-off at overload, short-circuit
protected)
19-30 GND
31 INIT
32 ERROR
33-35 N/C Not Connected
36 SELECTIN