User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
36 PM45 and PM45c Accessory User Guide
External Power Port
External Power Port Pinouts
6 End print Output Drives an applicator or other external device requiring
synchronization with the print cycle. Choose between four
types of output signals:
• Type 1 (Default): Asserted LOW for 20ms when label has
finished printing and positioned. Not asserted during
continuous printing.
• Type 2: Asserted HIGH for 20ms when label has finished
printing and positioned. Not asserted during continuous
printing.
• Type 3: Asserted LOW only when media is moving,
otherwise de-asserted HIGH.
• Type 4: Asserted HIGH only when media is moving,
otherwise de-asserted LOW.
7 Reprint Input Reprint mode is enabled in software. When this mode in
enabled, assert LOW to reprint last label. This input is
ignored when Reprint mode is disabled.
8 Reserved
9 Reserved
10 Ribbon/
Media low
Output Goes LOW when the ribbon/media roll diameter drops
below a predefined level, otherwise goes HIGH.
Media low is supported only by I-Style.
11 Reserved
12 +24VDC Output Power for external devices: +24VDC (±10%) @2A.
13 +5VDC Power Voltage supply for external sensors. Configurable for
internal or external source.
14 Power ground Ground +24VDC return.
Pin Signal Type Description
Pin Signal Type Description
1 +5VDC Input +5VDc input for distribution through Applicator Port connector
(Z-Style pin 2, S-Style pin 13)
2 Signal
ground
Input Signal return for +5VDC supply (Z-Style pin 1, S-Style pin 2)
3 +24VDC Input +24VDC input for distribution through Applicator Port connector
(Z-Style pin 7, S-Style pin 12)
4 Power
ground
Input Power return for input (Z-Style pin 8, S-Style pin 2)