User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
CHAPTER
3
PM45 and PM45c Accessory User Guide 53
INSTALLING ACCESSORIES
Label Dispenser
The label dispenser accessory for the PM45 and PM45c printer self-strips the label
and removes the liner from the self-adhesive label stock.
Out of the Box
• Label dispenser
Installation
You will need a torx screwdriver to install the label dispenser.
1. Open media cover.
2. Remove the front access door. (See page 5)
3. Remove the three screws that attach the tear bar to the printer and remove it.