User Manual

70 PM45 and PM45c Accessory User Guide
8. Slide the oil-saturated felt washer and the reflective wheel onto the metal rod.
Make sure the reflective side of the wheel faces the inside wall of the printer.
9. Put two of the 1 7/8-inch rotation core pieces together, making sure that the
alignment pins in one piece insert onto the alignment holes on the other piece.
When inserted correctly, the two core pieces should line up perfectly and be in
the exact same orientation.
10. Slide the two core pieces onto the metal rod and make sure the alignment pins
on the core piece insert into the alignment holes on the reflective wheel.
11. Connect the second two 1 7/8-inch core pieces together and slide onto the
metal rod. Make sure the alignment pins on the second set of core pieces line