User Manual
Table Of Contents
- PM45 and PM45c Interface Boards and Accessories
- Customer Support
- Introduction
- Installing Interface Boards
- Industrial Interface Board
- IEEE 1284 Parallel Board
- RFID Interface Board
- Applicator Interface Board
- Printer Firmware
- Out of the Box
- Installing the Applicator Interface Board
- Interfacing
- Applicator Signals
- Configuring Applicator Port Settings
- About Applicator Input Signals
- About Applicator OUT Signals
- Programming Applications for the printer
- Fingerprint Commands for the printer
- Using External Applicator Signals
- Error Messages
- Display Messages
- Wi-Fi/Bluetooth Interface Board
- Installing Accessories
- Wall Mounting Template
PM45 and PM45c Accessory User Guide 91
Dome Media Cover
The PM45c printer has option to install dome media cover to hold larger media
core and to protect the inside of the printer from dust and debris.
Out of the Box
• Dome media cover
• Transparent dome
• Two #T20 screws
Installation
You will require a small wrench and a torx screwdriver to install the short media
cover.
1. Remove the standard media cover. (See page 2)
2. Remove the two torx screws located at the back of printer.