Quick Start Guide Lyric T5 Wi-Fi Thermostat
Mercury Notice: If this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. Contact the Thermostat Recycling Corporation at 1-800-238-8192 or thermostat-recycle.org for information on how and where to properly and safely dispose an old thermostat. DISCONNECT POWER BEFORE INSTALLATION. Can cause electrical shock or equipment damage.
Welcome The Lyric T5 Wi-Fi Thermostat is a Wi-Fi® enabled comfort system designed to be easy to use, as well as maximize your home comfort. Lyric T5 Wi-Fi thermostat provides control of single stage and multi stage conventional and heat pump heating and cooling systems. Key features: • Connect to the Internet and control your heating/cooling system from anywhere with your smart devices. • View and change your heating/cooling system settings.
Included in your box: Thermostat Screwsand and Anchors Anchors Screws Honeywell Standard 16 Connector (S16) M35955 Optional Accessories Available: 3-29/32 (99) 6-7/64 (155) 4-49/64 (121) 3-57/64 (99) 6-7/64 (155) 4-49/64 (121) Honeywell Standard Installation Adapter Honeywell Decorative Cover Plate – Small Honeywell Decorative Cover Plate – Large 3-29/32 in (99mm.) x 4-49/64 in (121mm.) x 6-7/64 in (155mm.) x 3-57/64 in (99mm.) 4-49/64 in (121mm.) 6-7/64 in (155mm.
Tools you will need: Phillips screwdriver Small flat head screwdriver Ballpoint pen Honeywell Lyric app To configure your system and connect to your smartphone Needle-nose pliers* Wire stripper* Drill and drill bit (7/32")* Smartphone To photograph your existing wiring and access the thermostat app *Tools you might need 5
Installation The Lyric T5 Wi-Fi Thermostat should be mounted in a suitable location. • Install the thermostat about 5 ft. (1.5m) above the floor in an area with good air circulation at average temperature. See Fig. 1. • Do not install the thermostat where it can be affected by: –– Drafts or dead spots behind doors and in corners. –– Hot or cold air from ducts. –– Radiant heat from sun or appliances. –– Concealed pipes and chimneys. –– Unheated (uncooled) areas such as an outside wall behind the thermostat.
1 Turn OFF power (important!) To protect yourself and the equipment, turn OFF the power at the breaker box or switch that controls your heating/ cooling system. OR Switch Breaker box 2 Make sure the power is OFF! Try turning ON your heating/cooling system by changing the temperature. If you can’t get the system to turn ON in 5 minutes, you’ll know the power is OFF. 3 Take the faceplate off your old thermostat. On most thermostats, you can take off the faceplate by grasping and gently pulling.
4 Make sure there are no 120/240V wires. Do you have thick black wires with wire nuts? Is your thermostat 120V or higher? If you answered yes to either of these questions, you have a line voltage system and the Lyric thermostat will not work. Wire nuts Thick black wires If you are unsure visit: yourhome.honeywell.com/support 5 Take a picture of how your wiring looks right now. Be sure to include the letters next to the terminals where the wires are inserted.
6 Record if you have wires in the following terminals. Do no include jumpers. Check all that apply: Terminal Color of Wire R Rc RH 7 Record the existing wire configuration. Note the color of the wires that are plugged into your old thermostat’s terminals. You will need this information to correctly wire your Lyric thermostat. Terminal L Color of Wire Terminal Color of Wire K C G W2 Y2 W Y U1 U2 If there are wires in terminals that are not listed, you will need additional wiring support.
8 Disconnect wires & remove the old thermostat’s wall plate. Use a screwdriver or a ballpoint pen to release wires from terminals. Tip: To prevent wires from falling back into the wall, wrap the wires around your ballpoint pen. 9 Insert the wall anchors (included). It is recommended that you use the screws and wall anchors included in the box when mounting your thermostat. You can use the Honeywell Standard 16 Connector to mark where you want to place the wall anchors. Drill bit size 7/32”.
10 Check for any paint gaps or screw holes left by the old thermostat. If you choose to use the optional Honeywell Decorative Cover Plate and Standard Installation Adapter to hide blemishes, snap the Connector to Installation Adapter. For more information see page 12. 11 S1 L/A A S1 AUX W2 Y AUX W2 Y2 E G O/B C Bundle and insert wires through the new Honeywell Standard 16 Connector. Gather the wires and guide them through the hole in the middle of the Standard 16 Connector.
OPTIONAL: Use either small or large Decorative Cover Plate sold separately to cover any paint gaps or screw holes left by the old thermostat. (For more info where to purchase thermostat accessories, go to yourhome.honeywell.com) First attach Connector to Installation Adapter (picture 1 and 2). In the next step, attach Decorative Cover Plate to create a tight fit of the thermostat to wall (picture 3).
12 K Review your answer from Step 6. Set the R-switch up or down based on your wiring notes in Step 6. R If there is only one wire connected to R, then your system uses this wire to power both heating and cooling. Set the R-switch to the up position. 13 Firmly connect remaining wires from Step 7. L/A S1 O/B RC If you have an R or Rh, and Rc wire, then your system uses R or Rh to power the heating system and Rc to power the cooling system. Set the R-switch to the down position.
Mount the Standard 16 Connector. S1 L/A A S1 AUX W2 Y AUX W2 Y2 E G O/B C Mount the Standard 16 Connector using the provided screws and anchors. Install all (3) anchors & screws for a secure fit on your wall. Make sure the Standard 16 Connector is level, ideally by using bubble level, keeping the bubble between the two lines.
17 Log in to configure and connect Your Lyric thermostat is not yet configured to control your heating/cooling system. To complete your setup, download the Lyric App and register a new account or enter an existing account. Android Search Google Play for Honeywell Lyric. Create an account and log in to configure and connect. iOS Search the App Store for Honeywell Lyric. Create an account and log in to configure and connect.
How to use your Lyric T5 Wi-Fi Thermostat • Actual time / ISU or Alert number • Schedule information –– Following time based schedule or geo-location-based schedule. • System status information –– Cool On, Heat On (Emergency Heat On), Auto changeover On • Indoor temperature set-point –– Touch + and – to change temperature setting and select Hold until time or Permanent hold. • Indoor temperature • Mode –– Select system mode Heat/Cool/Off/EM Heat (emergency heat).
How to use your Lyric app Access the menu Use shortcuts to easily activate your favorite settings Change mode heating, cooling, or off Set away View weather forecast Set desired temperature Interested in more Lyric products? Visit yourhome.honeywell.com to learn about all available products connected by the Lyric app. App is regularly enhanced and may change.
Get the most from Lyric T5 Wi-Fi Thermostat Diverse programming options that fit any lifestyle: 1. 2. 3. 4. Location-Based scheduling – Lyric thermostat uses your smartphone’s location to know when you’re away, and saves you energy. Through geofence technology, it senses your return and helps make you comfortable upon arrival. You can also manually override your current setting when you’ll be out for a few hours by using the Away button on the thermostat or in the app.
Frequently Asked Questions Will Lyric thermostat still work if Wi-Fi connection is lost? Yes, the temperature can be adjusted directly at the thermostat. However, some features, including shortcuts and geofencing, are managed only through the Lyric app and will not function while the connection is down. The Lyric thermostat will automatically reconnect to Wi-Fi once the network is restored. Lyric thermostat is not finding the in home Wi-Fi network. Lyric thermostat operates in the 2.4GHz range.
Frequently Asked Questions How are multiple users set up with Lyric thermostat? Access can be given to any or all Lyric thermostat locations through the Lyric app. Start by pressing the three-line menu icon in the upper left-hand corner of the home screen. Press the gear wheel next to the location name. Select Users and press + Add User located at the bottom of the screen. Type in the email address of the person to be invited.
Regulatory information FCC Compliance Statement (Part 15.19) (USA only) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.
Notes 22
Notes 23
Wi-Fi® is a registered trademark of Wi-Fi Alliance® Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 yourhome.honeywell.com ® U.S. Registered Trademark. © 2016 Honeywell International Inc. 33-00151—01 M.S. 03-16 Printed in U.S.A.