Resideo RCHW3610WF Installation Guide

5
5 Placement
Place the bottom of your detector flat on the floor or a surface.
For wall mounting, use the included screw and hang the
detector on the bottom cover’s mounting keyhole.
Optional cable sensor
To install the optional cable
sensor, remove the sensor
jack plug and insert the cable
sensor. Insert the sensor jack
plug at the end the cable
sensor.
Accessory cable sensors (sold
separately) can be connected
to extend the cable and
increase water sensing area.
The entire length of cable is an extended sensor. You
can hang the detector from the wall or place both the
detector and cable sensor on the floor.
Note: The cable sensor jack is NOT for plugging in a
power adaptor. Doing so could damage the detector.
Sensors
Mounting
keyhole
Cable
sensor jack
Sensor jack
plug