Install Instructions

RM7898A 7800 SERIES VALVE PROVING PRIMARY RELAY MODULES
17 66-1161—04
Fig. 24. Sequence Status LEDs.
SETTINGS AND ADJUSTMENTS
Selectable Site-Configurable
Jumpers
The relay module has three site-configurable jumper options,
see Fig. 24 and Table 8 on page 18. If necessary, clip the site-
configurable jumpers with side cutters and remove the
resistors from the relay module.
SERVICE NOTE: Clipping and removing a site-configurable
jumper enhances the level of safety.
IMPORTANT
Clipping and removing a jumper after 200 hours of
operation causes a nonresettable Fault 110. The
relay module must then be replaced.
HONEYWELL
POWER
PILOT
FLAME
MAIN
ALARM
RESET
OPTIONAL
KEYBOARD
DISPLAY
MODULE
(STANDARD ON
RM7800G,L)
PURGE
TIMER
WIRING
SUBBASE
CAPTIVE
MOUNTING
SCREW
RUN/TEST
SWITCH
CONFIGURATION
JUMPERS
RELAY
MODULE
SEQUENCE
STATUS
LED PANEL
RESET
BUTTON
FLAME
AMPLIFIER
SCROLL
MODE
- SAVE -
BURNER CONTROL
M23166