User Manual

20 RP2/RP4 User Guide
3. Change (or confirm) the following parameter settings:
• ESSID: Type the name of your access point (Default D-O)
• Network Type: Infrastructure or Ad-hoc
4. After updating the New Value column, click the Send button to send this
change to the printer.
5. Allow 30 seconds for the printer to reset.
Note: To validate a successful Wireless LAN connection, the IP address obtained from the
access point is shown on the printer’s LED display.
Wireless LAN Security
The printer can be configured to use several wireless LAN security protocols.
WEP 64 and 128 Bit
1. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
2. Under Printer Information, click on WIFI.
3. Click on Static WEP.
4. Change (or confirm) the following parameter settings:
• WEP Selected Key: Select the key number to use
• WEP AP authentication: If users share 40 bit, use 64 bit encryption.
If users share 128 bit, use 128 bit encryption.
• WEP Data Encryption: Enable WEP Data Encryption
• WEP Key #1-4: Enter the WEP keys used by your access point
5. After updating the New Value column, click the Send button to send this
change to the printer.
6. Allow 30 seconds for the printer to reset.
WPA2-PSK with CCMP
1. Open the NETira CT Printer Configuration Utility Tool and click on Tools -
Query Printer Configuration (or press CTRL-q) to query the printer.
2. Under Printer Information, click on WIFI.
3. Click on WPA/WPA2.
4. Change (or confirm) the following parameter settings:
• Group Cipher: CCMP
• Network Authentication Type: WPA2-PSK
5. Type the pass phrase under WPA_PSK_TKIP/WPA2_PSK settings.