User Manual
Table Of Contents
- RP2B/RP2D/RP4B/RP4D
- Thermal Printers
- Table of Contents
- Customer Support
- Get Started
- Load the Media
- Program the Interface
- Printer Display and Buttons
- Calibration
- Configuration Files
- Maintenance
- Troubleshooting
- Product Specifications
- Accessories
- Printer Language Emulation
- Print Demo
2 RP2/RP4 User Guide
•Print Media
Honeywell offers a full line of applicable printing labels, receipt media, and
supplies.
About the Battery
Power is supplied to the printer by a rechargeable lithium ion battery. Batteries are
shipped only partially charged. The battery should be charged for a minimum of 4
hours before initial use to ensure optimal performance.
See Battery Charge Information on page 33 for further information about the bat-
tery.
Charge the Battery
1. Remove the battery from the printer then remove the red battery isolator.
2. Reinstall the battery in the printer. Align the release tab with the same side as
the charge contacts and lock the battery into position. The latch clicks into
Warning: The maximum operating temperature of the printer is 122ºF
(50°C), however the maximum operating temperature for
charging when used with a Honeywell power supply is limited
to 104ºF (40°C). Charge the printer in a location that meets this
temperature requirement.