Quick Start Guide

8
Labels don’t match or have
heat pump system?
See User Guide.
1.6c In the image on the right, check
the box next to each connection.
You will use this checklist in
Step 1.9.
1.6d Verify wire is firmly secured by
gently pulling on wire.
1.6e Repeat steps a–d for all other
wires.
1.6f Push any excess wire back into
the wall opening after all wires
are installed.
Note: The L terminal on the lower right is
used only for Heat Pump systems.
Note: If the old Heat Pump thermostat
had separate wires on Aux and E,
connect the Aux and E wires and one end
of a new piece of wire using a wire nut
(not included). Then slide the other end of
the new wire into the W2-Aux/E terminal.
Important!
Check the box for each wire
you connect. You will need
this information in Step 1.9.
C
Rc
R
W-O/B
Y
G
W2-
Aux/E
Y2
L