Spec Sheet

FEATURES

TRANSFER SWITCHES

Sync

™

Smart Switch

WITH LOAD SHEDDING CAPABILITY

100 - 400 Amps, Single Phase

Honeywell Sync Switches are designed for use with single phase generators.

The 100, 150, 200 and 400 amp open transition switches are available in single

phase in both service rated and non-service rated configurations.

All Honeywell Sync Switches are housed in an aluminum NEMA/UL Type 3R

enclosure*, with electrostatically applied and baked powder paint. The Heavy

Duty Generac Contactor is a UL recognized device, designed for years of service.

The control at the generator handles all the timing, sensing and exercising

functions.

DLM

TECHNOLOGY

Through the use of Digital Load Management technology

(DLM), each of these switches has the capability to truly manage two air

conditioning loads with no additional hardware. When used in tandem with the

individual DLM modules, up to four more additional loads can be intelligently

managed individually.

DPM Technology (single phase switches only)

Through the use of digital power

technology (DPM), each of these switches have the capability to manage up to 4

individual HVAC (24V controlled) loads with no additional hardware. When used in

tandem with Smart Management modules, up to 8 more loads can be managed

as well, providing the most installation efficient power management

options available.

* The 400 amp Non-Service Rated Switch is housed in a steel enclosure.

PAGE 1
TRANSFER SWITCHES Sync™ Smart Switch WITH LOAD SHEDDING CAPABILITY 100 - 400 Amps, Single Phase FEATURES ¡ Honeywell Sync Switches are designed for use with single phase generators. The 100, 150, 200 and 400 amp open transition switches are available in single phase in both service rated and non-service rated configurations. ¡ A ll Honeywell Sync Switches are housed in an aluminum NEMA/UL Type 3R enclosure*, with electrostatically applied and baked powder paint.
PAGE 2
FUNCTIONS All Timing and sensing functions originate in the generator controller • Utility voltage drop-out <65%* • Timer to generator start 5 second factory set, adjustable between 2-1500 seconds • Engine warm up delay 5 seconds* • Utility voltage pickup >80%* • Re-transfer time delay 15 seconds • Engine cool-down timer 60 seconds* • Exerciser 5 minutes every 2 weeks* The transfer switch can be operated manually without power applied.