Use and Care Manual

8 FT LED ALUMINUM SHOP LIGHT

MODEL: SH660XX1QXXX

USE AND CARE GUIDE

PROBLEM

Light will not come on.

A. Light not plugged into outlet.

B. Pull chain not engaged.

C. Outlet not powered.

A. Plug power cord into outlet.

B. Pull chain to activate light.

C. Check to make sure breaker is

on and test with another working

electrical device to make sure it

is receiving power.

POSSIBLE CAUSE SOLUTION

FCC WARNING:

WARNING: Changes or modifications to this unit not expressly approved by the party responsible

for compliance could void the user authority to operate the equipment.

NOTES: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

TROUBLE SHOOTING

International Development, LLC.

899 Henrietta Creek Rd. Roanoke, TX 76262 USA

Toll-free: 1-877-723-0723

The Honeywell Trademark is used under license from Honeywell International Inc.

Honeywell International Inc. makes no representations or warranties with respect to this product.

This product is manufactured for International Development, LLC.

PAGE 1
TROUBLE SHOOTING PROBLEM Light will not come on. POSSIBLE CAUSE A. Light not plugged into outlet. B. Pull chain not engaged. C. Outlet not powered. SOLUTION A. Plug power cord into outlet. B. Pull chain to activate light. C. Check to make sure breaker is on and test with another working electrical device to make sure it is receiving power.
PAGE 2
SAFETY INFORMATION IMPORTANT: Read all safety precautions and installations carefully before installing or servicing this fixture. • Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a wet or damp surface or in water. • Assure that the fixture is mounted onto a structurally sound surface that will support the fixture. • The fixture is designed for use in a 120 VAC, 60Hz fused circuit. Do not use on a dimming circuit. • Do not look into the lights.