Quick Start Guide

ManualsBrandsHoneywell ManualsBackupSI800MS

getconnected.honeywell.com

Introduction

The wireless sounders SI800MS are designed for audible signalling and deterrent action within the protected

premises.

Operation

Operating modes

The indoor sounders SI800MS activate:

• An audible alarm in case of intrusion, alert or ﬁ re

• Entry exit beeps

Tamper Prooﬁ ng

Upon any attempt to open the cover, the sounder will sound.

Silencing the sounder

The sound stops sounding upon disarming the panel or after 180 seconds for intrusion alarms or 300

seconds for smoke alarms.

Mounting & Settings

The SI800MS sounders must be mounted far from any source of electrical interference, against a ceiling or as

high as possible against a wall, within the protected premises.

1. Remove the sounder cover.

2. Position the sounder base plate against the wall and mark the 3 securing holes and the tamper screw hole.

3. Bore using a 6mm drill bit checking that each hole is correctly centred.

4. Insert anchors to the wall.

5. Position and secure the sounder, preferably with countersunk screws. 3.5mm Ø x 30mm.

6. Hold the batteries in place and pull out the battery tab to power up the sensor.

7. The sounder is ready for registration.

32318413001 Rev.C

Wireless battery internal siren

SI800MS

Installation instructions English

(1) Init Button

(2) Battery tab

(3) Tamper

(4) Plastic collar

Summary of content (14 pages)

PAGE 1
Wireless battery internal siren SI800MS Installation instructions English Introduction The wireless sounders SI800MS are designed for audible signalling and deterrent action within the protected premises. Operation Operating modes The indoor sounders SI800MS activate: • An audible alarm in case of intrusion, alert or ﬁre • Entry exit beeps Tamper Prooﬁng Upon any attempt to open the cover, the sounder will sound.
PAGE 2
Wireless battery internal siren SI800MS Installation instructions English Registration The Control Panel / Sounder link being bi-directional, the SI800MS sounders must always be registered in their ﬁnal location. 1. 4 *https://international.mytotalconnectcomfort.com 2. Press the “Init Button” (see Figure 1) on the sounder. The initialisation phase is conﬁrmed by beeps up to 30 seconds, depending on the protocol used (tamper opened). 3.
PAGE 3
Wireless battery internal siren SI800MS Installationsanweisungen Deutsch Einleitung Die drahtlosen Sirenen SI800MS sind für die akustische Signalisierung und Abschreckung in geschützten Räumlichkeiten ausgelegt. Betrieb Betriebsarten Die Innenraumsirenen SI800MS erzeugen: • Einen akustischen Alarm im Falle eines Einbruchs, Alarms oder Brandes • Eingangs-/Ausgangstöne Manipulationsgeschützt Die Sirene ertönt bei jedem Versuch die Abdeckung zu öffnen.
PAGE 4
Wireless battery internal siren SI800MS Installationsanweisungen Deutsch Registrierung Die Verbindung zwischen Bedienfeld/Sirene ist bidirektional, weshalb die SI800MS-Sirenen immer an ihrem endgültigen Standort registriert werden müssen. 1. 4 *https://international.mytotalconnectcomfort.com 2. Drücken Sie die „Taste Initialisieren“ (Siehe Abbildung 1) auf der Sirene.
PAGE 5
Wireless battery internal siren SI800MS Guide d’installation Français Présentation Les sirènes intérieures sans ﬁl SI800MS sont destinées à la signalisation sonores et permettent un action préventive dans les locaux protégés. Fonctionnement Modes de fonctionnement Les sirènes intérieures SI800MS permettent de déclencher: • L’alarme sonore en cas d’intrusion, d’alerte ou de feu. • Bips de sortie et d’entrée. Autoprotection En cas de tentative d’ouverture du couvercle, la sirène retentit.
PAGE 6
Wireless battery internal siren SI800MS Guide d’installation Français Enregistrement La liaison entre le Hub evohome security/Sirène étant bidirectionnelle, il est obligatoire d’enregistrer les SI800Ms à leur emplacement déﬁnitif. 1. 4 *https://international.mytotalconnectcomfort.com 2. Appuyez sur le bouton « INIT » (1). La phase d’initialisation matérialisée par des bips dure jusqu’à 30 secondes selon le protocole utilisé (autoprotection ouverte). 3.
PAGE 7
Wireless battery internal siren SI800MS Installatie instructies Nederlands Inleiding De draadloze SI800MS-sirenes zijn ontwikkeld om panden te beveiligen door een hoorbaar alarmsignaal af te geven en hebben een afschrikwekkende werking. Bediening Bedrijfsmodi De SI800MS-sirenes voor binnen activeren: • een hoorbaar alarm in geval van een inbraak, waarschuwing of brand • piepjes bij het betreden en verlaten van het pand Sabotage-beveiliging Indien wordt geprobeerd de kap open te maken, gaat de sirene af.
PAGE 8
Wireless battery internal siren SI800MS Installatie instructies Nederlands Registratie De koppeling tussen bedieningspaneel / sirene is bidirectioneel. Daarom moeten de SI800MS sirenes altijd in hun deﬁnitieve locatie worden geregistreerd. 1. 4 *https://international.mytotalconnectcomfort.com 2. Druk op de knop “Init” (zie afbeelding 1) op de sirene. De initialisatiefase wordt bevestigd door pieptonen tot 30 seconden, afhankelijk van het gebruikte protocol (sabotage-beveiliging open). 3.
PAGE 9
Wireless battery internal siren SI800MS Instrucciones de instalación Español Introducción Las sirenas inalámbricas SI800MS se han diseñado para las señales sonoras y la acción disuasiva en el recinto protegido. Funcionamiento Modos de funcionamiento Las sirenas SI800MS para interiores activan: • Una alarma sonora en caso de intrusión, alerta o incendio • Pitidos de entrada y salida A prueba de manipulación La sirena emitirá un sonido al producirse cualquier intento de abrir la tapa.
PAGE 10
Wireless battery internal siren SI800MS Instrucciones de instalación Español Registro Al ser bidireccional el enlace entre el panel de control y la sirena, las sirenas SI800MS deben registrarse siempre en su ubicación deﬁnitiva. 1. 4 *https://international.mytotalconnectcomfort.com 2 Pulse el “Botón de activación” (ver Figura 1) en la sirena. La fase de inicialización se conﬁrma mediante pitidos de hasta 30 segundos, dependiendo del protocolo utilizado (tamper abierto). 3.
PAGE 11
Wireless battery internal siren SI800MS Instruções de instalação Português Introdução As campainhas sem ﬁos SI800MS são concebidas para sinalização sonora e ação dissuasora dentro de instalações protegidas. Operação Modos de operação As campainhas de interior SI800MS ativam: • Um alarme sonoro em caso de intrusão, alerta ou incêndio • Avisos sonoros de saída de entrada À prova de interferências Mediante qualquer tentativa de abrir a tampa, a campainha soará.
PAGE 12
Wireless battery internal siren SI800MS Instruções de instalação Português Registo Sendo a ligação Painel de controlo/Campainha bidirecional, as campainhas SI800MS devem sempre ser registadas na sua localização ﬁnal. 1. 4 *https://international.mytotalconnectcomfort.com 2 Pressione o “Botão Init” (ver Figura 1) na campainha. A fase de inicialização é conﬁrmada por avisos sonoros até 30 segundos, dependendo do protocolo usado (manipulação aberta). 3.
PAGE 13
Wireless battery internal siren SI800MS Istruzioni d’installazione Italiano Introduzione Le sirene senza ﬁli SI800MS sono progettate per la segnalazione acustica e l’azione deterrente all’interno dei locali protetti. Funzionamento Modalità operative La sirena per interni SI800MS attiva: • Un allarme sonoro in caso di intrusione, allerta o incendio • Bip in entrata e uscita Protezione antimanomissione In caso di tentativi di apertura del coperchio, la sirena suonerà.
PAGE 14
Wireless battery internal siren SI800MS Istruzioni d’installazione Italiano Registrazione Dal momento che il collegamento tra centrale di sicurezza e sirena è bidirezionale, le sirene SI800MS devono essere sempre registrate nella loro sede ﬁnale. 1. 4 *https://international.mytotalconnectcomfort.com 2. Premere il “Pulsante Inizializzazione” (fare riferimento alla Figura 1) sulla sirena.