Single Zone Thermostat Remote Access Setup Guide for connecting 2 zones EN
2-zone system example... HOME Smartphone App Boiler ZONE 1 Remote Access Gateway ZONE 2 18.0° 21.0° Zone 1 BDR91 Zone 2 Zone-1 Thermostat Zone-2 Thermostat Zone Valve BDR91 Zone Valve Boiler/Pump switched from Zone Valve end-switches • Two Thermostats per Gateway - Only two Thermostats can be connected to a single Remote Access Gateway at one time.
1 Bind Zone-1 Thermostat to Zone-1 Zone Valve Controller (BDR91) Press 15sec 1 Install and power BDR91 2 Press and hold the button Zone Valve Controller (see BDR91 instructions). for 15 seconds (until the red LED blinks rapidly) to clear any stored binding data. Press 10sec Press 5sec 3 Put BDR91 into BIND mode by pressing the button again for 5 seconds (until the red LED blinks slowly).
3 Connect Gateway to home internet router 4 Bind Gateway to Zone-1 Thermostat bnd Press 1sec Press 10sec 1 Put Gateway into BIND 2 Put Zone-1 Thermostat into mode by pressing BIND button on base. BIND mode by pressing below and right of display. bnd Press once 3 Send BIND signal by pressing 4 LED on Gateway should turn solid green (= good signal). BIND button again. few secs 5 21.
5 Set-up account and download the app 1 Visit www.mytotalconnectcomfort.com to create an account and register the Remote Access Gateway. You will need the MAC ID and CRC which can be found on the base of the Remote Access Gateway: LED on Gateway should turn solid green when successfully registered 2 Download the ‘Total Connect Comfort International’ app from your app store. Select your store 6 Use the Smartphone App to set up heating schedules and control your zones...
Troubleshooting Gateway LED Status Solution Lost communication with one or both zone Thermostats Check both Thermostats are powered and within RF range of the Gateway (see guidelines in instructions) Two Thermostats already bound to the Gateway The Gateway will not allow a third Thermostat to be bound.
getconnected.honeywell.com Approvals Conforms to protection requirements of the following directives: EMC: 2004/108/EC LVD: 2006/95/EC R&TTE: 1999/5/EC Hereby, Honeywell, declares that this Remote Access Gateway is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Honeywell Control Systems Ltd. Skimped Hill Lane, Bracknell Berkshire RG12 1EB www.honeywelluk.com © 2015 Honeywell International Inc.
