Wireless Thermometer with Atomic Clock User Manual
1413
SPECIFICATIONS
Main Unit
Indoor Temperature
Proposed operating range : -5.0°C to +50.0°C/
23.0°F to 122.0°F
Temperature resolution : 0.1°C/0.2°F
User-selectable (F° or C°) temperature display
Low battery indicator
Calendar and Clock
12/24 hour display in hh: mm format
Date format: month – day format
US Time Zone map
Day of the week: User-selectable in five languages
(English, Spanish, French, German, Italian)
Dual 4-minute crescendo alarms with a 5-minute snooze
Freeze pre-alarm with programmable time intervals
Wall Mount or Desktop option
Remote Sensor
Remote Temperature
Proposed operating range with
alkaline batteries : -20.0°C to + 70.0°C/
-4.0°F to + 158°F
Proposed operating range with
lithium batteries : -38.8°C to + 70.0°C/
-38.0°F to +158°F
Temperature resolution : 0.1°C/0.2°F
Low battery indicator
RF Transmission Frequency : 433 MHz
Maximum number of remote sensors : 1 (included)
RF transmission range : Maximum 100 feet
(30 meters)
Temperature transmission cycle : approximately
45 seconds
Power
Main unit : 2 AA size (UM-3) 1.5V batteries (not included)
Remote Sensor : 2 AA size (UM-3) 1.5V batteries (not included)
Dimensions
Main unit : 2.64(L) x 4.84(H) x 1.02(D) inches
Remote sensor : 2.37(L) x 4(H) x 1(D) inch
FCC STATEMENT
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modification to this unit not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
NOTE: This equipment had been tested and found to comply
with the limits for a Class B Digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment, installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
There is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to improve or correct turning the interference by
one or more of the following measures:
1. Reorient or relocate the receiving antenna
2. Increase the separation between the equipment and receiver.
3. Connect the equipment to an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio / TV technician
for help.