Barometric Weather Forecaster User Manual

19
19
WET
-5°C to 50°C
(23°F
to122°F)
OVER
70%RH
Contains excess
moisture
DRY
5°C to 50°C
(23°F
to122°F)
BELOW
40%RH
Contains inadequate
moisture
MAXIMUM AND MINIMUM READINGS
The maximum and minimum record of the indoor and remote temperature and
humidity will be automatically stored in the memory of the main unit (receiver).
To display the minimum, maximum or the current reading press MEM button.
If no button is pressed for the next 15 seconds, the unit will return to the current
temperature and humidity display.
To clear the memory, press and hold MEM button for two seconds and all
previously stored readings will be erased.
LOST COMMUNICATION
If the main unit display line for the remote sensor reading goes blank, press
and hold DOWN (▼) button for 2 seconds to begin a new signal search. If the
signal still isn’t received, please make sure that:
• The remote sensor is in its proper location.
• The distance between main unit and remote sensor(s) is not over 100
feet (30 meters)
• The path between units is clear of obstacles. Shorten the distance if
necessary.
• Fresh batteries are installed correctly in both remote sensor and main
unit.
If there is no reception, please perform the following steps:
20
• Bring the main unit and remote sensor close together.
• Remove four (4) small screws from the back of the remote sensor with
small Phillips screwdriver, and open the battery compartment.
• Remove the batteries from the battery compartment and reinstall them
in the same manner. Remote sensor LED indicator will flash showing
transmission of the signal.
• Remove the batteries from the main unit and reinstall them in the same
manner.
• On the main unit select the same channel number using CHANNEL
button as set on the remote sensor. The remote temperature and
humidity appeared on the main unit’s display will show that
transmission is being received successfully.
TRANSMISSION COLLISION
Signals from the other household devices such as wireless doorbells, home
security systems, and entry control, may interfere with this product or cause
temporary reception interruption. This is normal and will not affect the general
performance of the product. The transmission and reception of the temperature
and humidity readings will resume once the interference subsides.
WWVB RADIO CONTROLLED TIME
The NIST (National Institute of Standards and Technology) radio station
(WWVB) is located in Ft. Collins, Colorado. It transmits an exact time signal
continuously throughout the most of the continental United States at 60 KHz
frequency. The Barometric Weather Forecaster can receive this WWVB signal
through the internal antenna from up to 2,000 miles away. Due to the nature of
the Earth’s ionosphere, reception can be limited during the daylight hours. The
radio controlled clock will search for an alternate station that receives the