User Guide

or radio station, etc).

Accessing Pressure and Weather Forecast Window

From the main unit: Press UP or DOWN until the weather forecast icon

on the upper left of the

display starts flashing.

From the remote control: Press

Programming Pressure & Altitude Parameters

During initial power up, the weather station won’t operate (first 2 minutes), until the pressure and/or

altitude parameters are not configured. The Pressure and Weather Forecast Window will show the

pressure icon and abbreviation “inHg” flashing.

If no values are entered within first 2 minutes the unit will self-adjust to the default settings – inHg

(inches of Mercury) for pressure units and 33 feet for altitude.

To set the pressure and/or altitude units and program the altitude or adjust the sea level pressure

during these 2 minutes:

• Press UP or DOWN arrow button selecting the pressure in inHg(inches of mercury), hPa

(hectoPaskal)/mBar(millibars) or mmHg(millimeters of mercury)

• Press SET button to confirm and store selection. Then unit will advance to the altitude

unit selection

• Press UP or DOWN arrow button selecting the altitude unit in feet or meters.

NOTE: When adjusting altitude, be noted that the last small digit is not a decimal but a

whole number.

Example: “

350” feet means 350 feet (three hundred fifty feet).

• Press SET button to confirm and store your selection. Unit will advance to the altitude

programming

• Press UP or DOWN arrow button to adjust the altitude value. Press and hold either

button for the advanced setting.

• Press SET to confirm the selected altitude value.

• Wait for about 15 seconds until unit will calculate and display adjusted pressure

Viewing the Pressure and Altitude Information

To view a pressure or altitude information, press SET button selecting the sea level pressure, local

pressure and local altitude screens.

Changing or Setting Sea Level Pressure

• Press SET button until the local pressure with the word “SEA LEVEL” is displayed.

• Press and hold MEMORY button until the pressure unit is flashing, inHg, mmHg or

hPa/mBar