VisionPRO 8000 Spec Sheet 2017

VISIONPRO
®
8000 WITH REDLINK™
13 68-0312—05
Installing VisionPRO® 8000 with
RedLINK™
Connect Power
1. Insert supplied AA alkaline batteries for primary or
backup power.
Fig. 17. Insert AA batteries.
NOTE: When the thermostat is NOT used with the Equip-
ment Interface Module or the TrueZONE Wireless
Adapter, a C wire is required for RedLINK.
2. For 24VAC primary power, connect common side of
transformer to C terminal.
Fig. 18. Connecting C wire to terminal block.
Wiring the Thermostat
IF THE THERMOSTAT IS WIRED DIRECTLY TO THE
EQUIPMENT
1. Refer to Fig. 19. See Table 10 on page 122 for termi-
nal designations and “Wiring” beginning on
page 121 for more information.
2. Turn on 24VAC NOW.
NOTE: 24VAC (C wire) is required to connect
RedLINK accessories.
Fig. 19. Thermostat wired directly to equipment.
IF THE THERMOSTAT IS USED WITH AN EQUIPMENT
INTERFACE MODULE OR TRUEZONE WIRELESS
ADAPTER
1. Power the thermostat using Rc and C terminals or
with batteries. Refer to Fig. 20.
NOTE: The relay outputs and inputs on the thermo-
stat do not function when used with an
Equipment Interface Module or TrueZONE
Wireless Adapter.
Fig. 20. Inserting wires in thermostat terminal block.
Remove Coin Cell Battery Tab
1. Remove tab to activate coin cell battery.
NOTE: Coin cell battery saves time and date during a
power loss.
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP
S1
S1
W
Y
G
W2
Y2
A
S1
S1
O/B
Y
G
AUX
-E
Y2
L/A
K
RC
R
U1
U1
U2
U2
C
CONVENTIONAL
HEAT PUMP