Manual

T10 PRO SMART THERMOSTAT WITH REDLINK
13 33-00462—01
Fig. 27. Wired to fresh air damper powered by furnace
transformer.
Fig. 28. Wired to humidifier, ventilator, or damper
powered by external transformer.
Fig. 29. Wired to low speed fan terminal on HVAC for
dehumidification.
Mounting thermostat
1. Push excess wire back into the wall opening.
2. Close the UWP door. It should remain closed without
bulging.
3. Align the UWP with the thermostat, and push gently
until the thermostat snaps in place.
4. If needed, gently pull to remove the thermostat from
the UWP.
Fig. 30. Mounting or removing the thermostat.
Mounting Optional Accessories
Installing RedLINK indoor sensors
The C7189R2002-2 indoor sensor 2 pack is included with
the T10 thermostat. These sensors detect Temperature,
humidity and motion.
Damper
C from furnace
or air-handler
M37824
Humidifier,
dehumidifier,
or ventilator
R from 24 volt
transformer
C (common) from
24 volt transformer
M37825
Dehumidifier*
Furnace or
air-handler
* Label for this terminal
varies by equipment
M37826
M37822