Dehumidifier Manual

21
ERROR CODE GUIDE
EN
CODE POSSIBLE CAUSE NOTE
P1 Water tank pull out
This only appears for model
TP70P with Built-in Drain Pump.
Position the water tank correctly into the unit. Unit
will not operate until the water tank is secure in place.
EH Humidity sensor failure Please contact the service center.
E1 / E2
Temperature sensor
failure
Please contact the service center.
E3 Gas leakage
If E3 appears, Please the check the ambient
temperature range whether below 89.6°F (32°C).
If the ambient temperature over 89.6°F (32°C) place the
unit below 86°F (30°C) for 2 hours before running the
Dehumidifier again.
If the E3 appears again in 2 hours, please contact the
service center.
Electrical products should be properly disposed of. Please recycle where facilities exist.
Check with your local authority or retailer for recycling.