Install Instructions

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsPneumatic Thermostat Reverse Acting, Wall Thermostat, 1 or 2 pipe operation

TP9600-TP9630 Pneumatic

Thermostats

INSTALLATION INSTRUCTIONS

GENERAL

The TP9600 Series pneumatic thermostat provides

proportional control for pneumatic actuators in heating,

ventilating, and air conditioning systems.

FEATURES

• One, two, or three pipe

• Direct Acting and Reverse Acting

• One or two bimetal elements for Day-Night or

Heating-Cooling operation

• High capacity or one pipe low capacity devices

• Adjustable stops to limit setpoint adjustment

• Replaceable Air Filter

• Includes cover

SPECIFICATIONS

Air Pressure:

25 psi max

18 psi operating

Setpoint Pressure:

Factory set at 8 psi

Air Consumption:

0.011 scfm

Setpoint Range:

60 to 90 F typical

50 to 75 F setback

Throttling Range:

2 to 10 F, Factory set at 4 F

Air Connections:

5/32 barb fittings

Branch Line Port:

Self-Sealing tap accessible under cover

Maximum Ambient Temperature:

150 F

Mounting:

Vertical wall mount with plug in backplate

ACCESSORIES

14002430-001: Protective Guard, Standard

TG509F,G: Protective Versaguard, Key Lock

14004439-001: Setpoint Extension Lever

Common Repair Parts

14001865-001: Filter Cartridge Assembly

Kits

14004911-001: Adaptor Plate Assembly

This kit adapts the TP9600 to replace newer

Johnson, Powers, Robertshaw, and Kreuter

thermostats

14002573-001: Universal Modernization Kit

This kit adapts the TP9600 to replace older

Honeywell and other manufactures of larger

thermostats

95-7550

Summary of content (4 pages)

PAGE 1
TP9600-TP9630 Pneumatic Thermostats INSTALLATION INSTRUCTIONS SPECIFICATIONS GENERAL The TP9600 Series pneumatic thermostat provides proportional control for pneumatic actuators in heating, ventilating, and air conditioning systems.
PAGE 2
TP9600-TP9630 PNEUMATIC THERMOSTATS SEE CHART FOR BARB SIZE INSTALLATION A B These instructions cover mounting the thermostat to a wall without additional hardware. For replacement of existing competitive and older Honeywell thermostats, use the appropriate adapter kit and follow instructions packed with kit. FILTER INLET ALL INLET BARBS 1/4 IN. (6 MM) Installation Tools REMOTE RESTRICTORS The following tools will be useful during calibration check and cover installation: Part No.
PAGE 3
TP9600-TP9630 PNEUMATIC THERMOSTATS On reverse-acting, bimetal elements: ADJUSTMENTS 1. Turn setpoint up five degrees above actual room temperature as measured by a test thermometer, and allow thermostat to build up branchline pressure. 2. Turn down setpoint indicator (Fig. 4) slowly. 3. If thermostat begins to bleed off between 1F (0.5C) and 3F (1.5C) above room temperature, no further calibration is necessary.
PAGE 4
TP9600-TP9630 PNEUMATIC THERMOSTATS TP9620 Calibration CAUTION The thermostat is very sensitive and should not be heated by excessive handling during calibration. NOTE: Reference in the following procedures to a 30 psi gage implies the gage and gage adapter listed in INSTALLATION TOOLS section. TP9600 1. Remove the thermostat cover and install a 30 psi gage into the gage tap. 2. Set the temperature setpoint indicator at the indicated temperature. 3. Turn the calibration screw (see Fig.