User Guide

TStatSpec
TM
42
outputs or it can be used as second heating or cooling stage.
In this case, it will be labeled as Aux-Heating Stage2 or Aux-
Cooling Stage2.
G-FAN:
This is the fan output. This output can be commanded to ON/
OFF.
Current Sensor Values:
SPACE TEMP:
This is the space temperature value.
DISCHARGE TEMP:
This is the discharge temperature value.
NOTE:
The value will always be displayed as INVALID for T7350A,
1H1C thermostat.
T7350CS MODE:
This reflects the current T7350CS mode. If the outputs are in
manual mode, this field should reflect manual mode and if
they are driven by the control algorithm, these outputs should
reflect the auto mode.
SET:
Change the desired outputs and click on 'Set' button to set the
controller to manual mode and write the output values to the
controller. When the controller is set to manual mode, the
T7350CS Mode field reflects the manual mode.
REFRESH:
Click on this button to refresh the values in the screen.
CLOSE:
Click on this button to close the screen. When the controller is
put into manual mode through the 'Set' button and the screen
closed, a warning message is displayed:
WARNING
Controller is in Manual Mode. Do you want to put
to Auto Mode?
Selecting Yes will put back the controller to auto mode, while
selecting No will retain the controller in manual mode.
HELP:
Displays help for the T7350 diagnostic screen.
Upload from T7350
TStatSpec allows the user to upload configuration from a
device to TStatSpec. The T7350 allows configuration data to
be entered through keypad. It is possible that some invalid
data is entered to the thermostat. While uploading, TStatSpec
detects the invalid configuration and replaces those with
default values. If any such change is made, TStatSpec™
informs the user that an invalid configuration has been
replaced by the default configuration.