User Guide

TStatSpec
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
www.honeywell.com/buildingsolutions
® U.S. Registered Trademark
© 2010 Honeywell International Inc.
INTERNATIONAL INC. Nothing in this Agreement shall confer
any rights in any tradename, business name or trademark of
HONEYWELL INTERNATIONAL INC.
4. Governing Law. This Agreement shall be construed
and governed in accordance with the laws of the State
of Minnesota.
5. Severability. Should any term of this Agreement be
declared void or unenforceable by any court of compe-
tent jurisdiction, such declaration shall have no effect on
the remaining terms hereof.
6. No Waiver. The failure of either party to enforce any
rights granted hereunder or to take action against the
other party in the event of any breach hereunder shall
not be deemed a waiver by that party as to subsequent
enforcement of rights or subsequent actions in the event
of future breaches.
TStatSpec™ SOFTWARE © 2010, Honeywell Inc. All Rights
Reserved.
DISCLAIMER
The purpose of this help file or user’s guide is to provide the
reader with a fundamental understanding of TStatSpec, how
to install the software, how to navigate the software after it is
installed, and a basic understanding of how T7350 controllers
operate with the software in conjunction with commercial
heating, ventilating, and air conditioning applications. It is not
a manual on the fundamentals of these controllers.
Many aspects of building management control are presented
including air handling units, remote units, and displays.
Control fundamentals, theory, and types of controls are not
provided or are not provided in detail. It is assumed that the
user already has an understanding of these fundamentals and
theories including access to engineering data such as
equipment sizing, use of psychrometric charts, and
conversion formulas. However, to enhance understanding,
some definitions are provided. For maximum usability, each
section of this guide is to be treated as a separate document.
In addition, it is assumed the user has knowledge of the
basics of building management systems and configurations.
Any control recommendations in this guide are general in
nature and are not the basis for any specific job or installation.
Control systems are furnished according to the plans and
specifications prepared by the control engineer. In many
instances there is more than one control solution. Professional
expertise and judgment are required for the design of a
control system. This guide is not a substitute for such
expertise and judgment. Always consult a licensed engineer
for advice on designing control systems.
It is hoped that the scope of information in this guide will
provide the user with the tools to begin using their TStatSpec
software and make adjustments using their TStatSpec
software.
TSTATSPEC SOFTWARE © 2010, Honeywell Inc. All Rights
Reserved.
IMPORTANT—READ CAREFULLY:
1 DESCRIPTION OF OTHER RIGHTS AND LIMITATIONS.
Not for Resale Software. If the SOFTWARE PRODUCT is
labeled "Not for Resale" or "NFR", then, you may not resell, or
otherwise transfer for value, the SOFTWARE PRODUCT.
Limitations on Reverse Engineering, Decompilation, and
Disassembly. You may not reverse engineer, decompile, or
disassemble the SOFTWARE PRODUCT, except and only to
the extent that such activity is expressly permitted by
applicable law notwithstanding this limitation.
Separation of Components. The SOFTWARE PRODUCT is
licensed as a single product. Its component parts may not be
separated for use on more than one computer.
Rental. You may not rent, lease, or lend the SOFTWARE
PRODUCT.
Support Services. Honeywell may provide you with support
services related to the SOFTWARE PRODUCT ("Support
Services"). Honeywell may use such information for its
business purposes, including for product support and
development. Honeywell will not utilize such technical
information in a form that personally identifies you.
Termination. Without prejudice to any other rights, Honeywell
may terminate this agreement if you fail to comply with the
terms and conditions within. In such event, you must destroy
all copies of the SOFTWARE PRODUCT and all of its
component parts.
1 UPGRADES. If the SOFTWARE PRODUCT is labeled as an
upgrade, you must be properly licensed to use a product
identified by Honeywell as being eligible for the upgrade in
order to use the SOFTWARE PRODUCT. A SOFTWARE
PRODUCT labeled as an upgrade replaces and/or
supplements the product that formed the basis for your
eligibility for the upgrade.
2 U.S. GOVERNMENT RESTRICTED RIGHTS. The
SOFTWARE PRODUCT and documentation may be provided
with RESTRICTED RIGHTS. Use, duplication, or disclosure
by the Government is subject to restrictions as set forth in
subparagraph (c)(1)(ii) of the Rights in Technical Data and
Computer Software clause at DFARS 252.227-7013 or
subparagraphs (c)(1) and (2) of the Commercial Computer
Software—Restricted Rights at 48 CFR 52.227-19, as
applicable. Manufacturer is Honeywell, 1985 Douglas Drive,
Golden Valley, Minnesota 55422.
MISCELLANEOUS
If you acquired this product in the United States, this
agreement is governed by the laws of the State of Minnesota.
If this product was acquired outside the United States, then
local law may apply.