Install Instructions

VB6 series 6-Way Control Ball Valves and Actuators - Installation Instructions
31-00380M-01 6
Electrical Installation
The most important part of the electrical installation is the
power supply for the actuator.
CAUTION
To avoid personal injury (electrical shock) and
to prevent equipment damage, before
installation, you must remove power.
1. Unscrew the actuator wiring cover in order to access
to the terminal block(s) as shown below.
Figure 12. Removable Access Cover
2. Perform the wiring of actuator using Figure 13 to
Figure 15 as per the required application.
Figure 13. MN7510 (Modulating Mode).
Figure 14. MN7510 (Floating Mode).
Figure 15. MN7510 (2-Position Mode).
3. If necessary, use the appropriate electrical cable
conduits and cable gland to properly secure the
actuator wiring.
4. Replace the wiring cover once done.