Specifications

ManualsBrandsHoneywell ManualsHeatingHome-Resideo Continuous Pilot Dual Automatic Valve Combination Gas Control - NG or LP - Slow Opening - 1/2" In x 1/2" Out

Combination Gas Controls

70-6910 105

Home

Controls Indoor Air Quality

Residential

Combustion Controls Hydronic Controls

Water

Controls Building Automation

Commercial

Components Pneumatic Controls

Industrial Combustion

Controls

V400 Line Voltage; V800 Low Voltage Combination Gas Controls

Used on gas fired standing pilot appliances with 30 mV

thermocouple. These gas controls include a manual gas valve,

safety shutoff, single millivoltage automatic operator, and pressure

regulator, pilot gas filter and flow adjustment, pressure tapping,

and thermocouple connector. V800 is used on 24V systems.

• Include pilot flow adjustment screw.

• Easy to install, adjust and service; all adjustments and connections

are accessible from top of control.

• Add separate energy cutoff (ECO) where codes call for dual safety

shutoff.

• Complete safety shutoff on pilot flame failure.

• LITE-RITE (OFF-PILOT-ON) lighting sequence.

• ECO connector for V800 models. Part No. 392451-1.

Dimensions in inches (millimeters)

Type: Single Stage

Body Pattern: Straight-through, multi-tapped with 1/2 in. right and left

outlets plugged

Capacity @ 1 in. p.d. 335,000 BTU/hr; 295,000 BTU/hr minimum

Ignition Type: Standing Pilot

Ambient Temperature Range: 32 F to 175 F (0 C to 79 C)

Pressure Ratings: 1/2 psi (3.5 kPa)

Pressure Tapping: 1/8 in. NPT with plug

Frequency: 60 Hz

Pilot Gas Outlet: Compression fitting for 1/4 in. OD tubing

Mounting: 0 to 90 degrees in any direction from the upright position of

the gas control knob, including vertically.

Approvals:

American Gas Association: AGA Design Certified; File No. L2025003,

CGA Design Certified; File No. L2025003, UL Component

Recognized.

Underwriters Laboratories, Inc. UL Component Recognized.

PILOT CONNECTION

COMP. FITTING

FOR 1/4 O.D. TUBING

PRESSURE

TAP 1/8 NPT

MOUNTING

HOLES (2)

NO. 10-32 X

.25 DEEP

3-3/4 (95)

SWING

RADIUS

3-3/4 (95)

SWING

RADIUS

5/16 (8)

3-1/2

(89)

1-1/4

(32)

4-3/4

(121)

5/16 (8)

2-9/16

(65)

4-1/16 (103)

3-3/16 (81)

1-7/16

(37)

1-3/16

(37)

1-7/8

(48)

WITH V5306 (ILLUSTRATED), V5307 OR 5390 PRESSURE REGULATOR: 24V MODELS–3-1/2 (89), 120V MODEL–3-5/8 (92)

MANUAL MODELS–2-13/16 (71), FOR V5308 ADD 5/8 (16) TO DIMENSIONS GIVEN.

SIDE OUTLETS–LEFT AND RIGHT HAND. STANDARD ONLY ON TRADELINE MODELS.

CONTROL WITH 24V VALVE OPERATOR SHOWN. LINE VOLT MODEL HAS COVER FOR CONDUIT CONNECTION (TOP SURFACE).

ECO CONNECTOR ON STANDARD CAPACITY V800 ONLY.

M16547A

Product Number

Type

of Gas

Opening

Characteristics

(standard,

step)

Inlet/

Outlet

Size

(in.)

Pressure Regulator Setting

Electrical

Ratings Includes(psi) (kPa)

• V400A1095 Natural Standard 3/4 in. x

3/4 in.

3.5 in. wc 0.87 kPa 120 Vac Two 3/4 x 1/2 in.; One 1/2 x 3/8 in.

Reducer Bushing/Adapters

V400C1036 Natural Step Opening 3/4 in. x

3/4 in.

Full Rate: 3.5 in. wc;

Step Setting: 0.7 in. wc

Full Rate: 0.87 kPa;

Step Setting: 0.17 kPa

120 Vac —

* V800A1070 Natural

or LP

Standard 1/2 in. x

3/4 in.

3.5 in. wc 0.87 kPa 24 Vac One 1/2 in. x 3/8 in. reducer bushing,

One 3/4 in. x 1/2 in. reducer bushing,

Q340 Thermocouple,

Natural to LP Conversion Kit

* TRADELINE models • SUPER TRADELINE models

Summary of content (14 pages)

PAGE 1
Combination Gas Controls Residential Combustion Controls Dimensions in inches (millimeters) 3-3/16 (81) 5/16 (8) Indoor Air Quality Used on gas fired standing pilot appliances with 30 mV thermocouple. These gas controls include a manual gas valve, safety shutoff, single millivoltage automatic operator, and pressure regulator, pilot gas filter and flow adjustment, pressure tapping, and thermocouple connector. V800 is used on 24V systems. • Include pilot flow adjustment screw.
PAGE 2
Combination Gas Controls Opening Characteristics Type (standard, Product Number of Gas step) Inlet/ Outlet Size (in.) • V800A1088 Natural Standard or LP * V800A1476 * * Pressure Regulator Setting (kPa) Electrical Ratings Includes 3/4 in. x 3.5 in. wc 3/4 in. 0.87 kPa 24 Vac One 1/2 in. x 3/8 in. reducer bushing, One 3/4 in. x 1/2 in. reducer bushing, Q340 Thermocouple, Natural to LP Conversion Kit Natural Standard or LP 1/2 in. x 3.5 in. wc 3/4 in. 0.
PAGE 3
Combination Gas Controls 120V THERMOSTAT HIGH LIMIT CONTROLLER 3 L1 (HOT) L1 1 L2 GAS CONTROL TERMINALS L2 2 1 POWER SUPPLY. PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED. 3 OPTIONAL HIGH LIMIT. Pressure Regulator Setting Product Number Opening Characteristics Type of Gas (standard, step) Inlet/Outlet Size (in.) (psi) (kPa) Electrical Ratings VR4300A4502 Natural 3/4 in. x 3/4 in. 3.5 in. wc 0.
PAGE 4
Combination Gas Controls VR8200 Continuous Pilot Dual Automatic Valve Combination Gas Controls Combination gas controls for use in 24 Vac, gas-fired, standing pilot appliances with capacities from 20 to 200 cfh. • Controls include manual valve, two automatic operators, servo pressure regulator and pilot adjustment. • Compact size. • Provide two automatic valves. • Solenoid-operated first automatic valve opens on thermostat call for heat; closes when call for heat ends.
PAGE 5
Combination Gas Controls Home Controls VR8300 Continuous Pilot Dual Automatic Valve Combination Gas Control 1/4 INCH QUICK-CONNECT TERMINALS (FOR FLANGE MOUNTING) 8-32 TAPPED (4) TH TR 3-15/16 (99) 1 1/2 1 (13) (25) Approvals: American Gas Association: AGA Design Certified: File No. L2025006. Canadian Gas Association: CGA Design Certified: File No. L2025006. Underwriters Laboratories, Inc. UL Component Recognized. 2 1 (25) 4-1/16 (104) 1 FLANGE FACTORY MOUNTED ON 3/4 X 3/4 INCH MODELS ONLY.
PAGE 6
Combination Gas Controls * Product Number Opening Pressure Regulator Setting Type of Characteristics Inlet/Outlet Size Gas (standard, step) (in.) (psi) (kPa) Includes VR8300C4506 Natural Step Opening 3/4 in. x 3/4 in. Full Rate: 3.5 in. wc; Step Setting: 0.9 in. wc Full Rate: 0.87 Two 3/4 x 1/2 in. reducer bushings kPa; Step Setting: 0.22 kPa VR8300H2109 Natural Slow Opening 1/2 in. x 1/2 in. 3.5 in. wc 0.87 kPa — VR8300H4501 Natural Slow Opening 3/4 in. x 3/4 in. 3.5 in. wc 0.
PAGE 7
Combination Gas Controls Home Controls VR8204 Intermittent Pilot Dual Automatic Valve Combination Gas Controls 1/4 in. QUICKCONNECT TERMINALS 3-5/8 (91) SWING RADIUS PV PV/MV MV 3-1/2 (89) 1/2 (13) 1 (25) 1-7/16 (36) 1 (25) 2-11/16 (69) (psi) Product Number (kPa) (F) (C) Includes VR8204A2076 Natural Standard 1/2 in. x 3.5 in. wc 1/2 in. 0.87 kPa 0 F to 175 F -18 C to +79 C One 3/4 in. straight flange One 1/2 in. x 3/8 in.
PAGE 8
Combination Gas Controls VR8245 Intermittent Pilot Combination Gas Control These universal electronic ignition gas controls are used in gasfired appliances with capacities up to 150 cu ft/hour at 1 inch wc pressure drop (4.2 cu m/hour at 0.25 kPa) for natural gas. The VR8245M will operate with a direct spark (DSI), hot surface (HSI) or intermittent pilot ignition. The control includes a manual valve, two automatic operators, a pressure regulator, pilot adjustment, pilot plug and ignition adapter.
PAGE 9
Combination Gas Controls Home Controls VR8304 Intermittent Pilot Dual Automatic Valve Combination Gas Control 1/4 in. QUICKCONNECT TERMINALS 4 in. (102) SWING RADIUS 3-15/16 (99) PV PV/MV MV 1/2 (13) Approvals: American Gas Association: AGA Design Certified: File No. L2025007. Canadian Gas Association: CGA Design Certified: File No. L2025007. Underwriters Laboratories, Inc. UL Component Recognized.
PAGE 10
Combination Gas Controls VR4305 Direct Ignition Dual Automatic Valve Combination Gas Control Combination gas control for use with hot surface/direct spark systems in 120 Vac, gas-fired appliances, with capacities from 30 to 415 cfh. • Controls include manual valve, two automatic operators and pressure regulator. • Compact size. • Provides two automatic valves. • Solenoid operated first automatic valve opens on thermostat call for heat; closes when call for heat ends.
PAGE 11
Combination Gas Controls Home Controls VR8205 Direct Ignition Dual Automatic Valve Combination Gas Controls (FOR FLANGE MOUNTING) 8-32 TAPPED (4) 3-5/8 (91) SWING RADIUS 1/4 in. QUICKCONNECT TERMINALS MV MV 3-1/2 (89) 1/2 (13) Approvals: American Gas Association: AGA Design Certified: File No. L2025006. Canadian Gas Association: CGA Design Certified: File No. L2025006. Underwriters Laboratories, Inc. UL Component Recognized.
PAGE 12
Combination Gas Controls VR8305 Direct Ignition Dual Automatic Valve Combination Gas Control Combination gas control for use with hot surface/direct spark systems in 24 Vac, gas-fired appliances, with capacities from 30 to 415 cfh. • Controls include manual valve, two automatic operators, and pressure regulator. • Use with S89C,E,F and S87 series 5 and later. • Compact size. • Provide two automatic valves.
PAGE 13
Combination Gas Controls 4 in. (102) SWING RADIUS 1/4 in. QUICKCONNECT TERMINALS PV 3-15/16 (99) PV MV MV 4-1/16 (104) 2-11/16 (69) Type of Product Number Gas M7449B Pressure Regulator Setting Opening Characteristics Inlet/Outlet Size (standard, step) (in.) (psi) (kPa) Ambient Temperature Range (C) Natural Slow Opening 3/4 in. x 3/4 in. 3.5 in. wc 0.87 kPa 0 F to 175 F -18 C to +79 C VR8345M4302 Natural Standard 3/4 in. x 3/4 in. 3.5 in. wc 0.
PAGE 14
Millivoltage Combination Gas Controls VS820 Millivoltage Combination Gas Controls These gas controls combine a Lite-Rite manual gas cock, safety shutoff Pilotstat assembly, millivoltage automatic valve operator, and optional gas pressure regulator. They require the use of a 750 mv Powerpile generator (thermopile). The generator, heated by the pilot burner flame, provides the electrical energy to operate the combination gas control.