Operator's Manual

69-1353 10
Table 1. Alert Messages.
ACKNOWLEDGING ALERT MESSAGES
You will hear, “To acknowled
g
e the alert messa
g
e, press
1.”
After the alert messa
g
e is announced, the Telephone
Access Module prompts
y
ou to acknowled
g
e the alert
messa
g
e b
y
pressin
g
1. If there is more than one active
alert messa
g
e, the Telephone Access Module indicates
the next messa
g
e, and continues until all alerts are
announced.
When
y
ou acknowled
g
e the alert messa
g
e,
y
ou are
clearin
g
the dial-in alert messa
g
e and also clearin
g
the
dial-out alert.
IMPORTANT:
After receiving an alert, it is important to take
appropriate action immediately. See Receiv-
ing Dial-Out Messages section for more infor-
mation on dial-out alerts.
The Telephone Access Module continues throu
g
h the
menu after the alerts are announced.
To exit, press the * ke
y
at an
y
time.
Alert Message Possible Cause
Hi
g
h Temperature The room temperature exceeded the hi
g
h-limit temperature settin
g
.
Low Temperature The room temperature exceeded the low-limit temperature settin
g
.
Heat Pump A heat pump compressor fault occurred.
Heatin
g
S
y
stem The s
y
stem heat output is below the acceptable performance; possible heatin
g
s
y
stem failure.
Coolin
g
S
y
stem The s
y
stem cool output is below the acceptable performance; possible coolin
g
s
y
stem failure.
Auxiliar
y
Input The auxiliar
y
sensor connected to the auxiliar
y
input terminals tripped.
Filter Chan
g
e The thermostat is indicatin
g
that a filter chan
g
e is required for the heatin
g
/coolin
g
s
y
stem.
Power Outa
g
e A power outa
g
e exceeded the maximum allowable time.
80
90
70
60
90
80
70
60