Technical Manual

XNX Universal Transmitter
Section 1 - Introduction
21
Figure 19. Passcode screen
Warning: The factory-set passcodes must be reset to prevent
unauthorized access to the transmitter’s menus.
When the Passcode Screen is displayed, the rst passcode
digit is highlighted. Use the switches to increment or
decrement through the values. Once the correct value is
displayed for the rst digit,
✓
accepts the value and moves to
the next digit or
✖
moves to the previous digit of the passcode.
✓
Figure 20. Entering the passcode
Repeat for each of the remaining digits in the passcode. If the
passcode is not entered correctly, the Invalid Passcode screen
is displayed and the user is returned to the General Status
screen.
Figure 21. Invalid Passcode screen
1.4.4 Displaying Transmitter Information
While in the General Status display, swipe the magnet over the
magnetic switch
to display information about the transmitter.
The General Status display will replace the bar graph in the
lower portion of the screen with the unit’s serial number, the
date and time, and the unit’s part number.
Figure 22. General Status Screen with Unit Information