Submittal Sheet

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsLCBS Connect Controller and Commercial Thermostat (3H/3C)

Table Of Contents

SPECIFICATION DATA

31-00124-01

LCBS Connect

Controller and Wall Module

GENERAL

The LCBS Connect controller and wall module

combination have been designed to control Constant

Volume Air Handling Unit, Heat Pump application, and

their configurations. With the embedded control logic and

integral temperature, humidity sensors, they control the

space temperature in a given zone by regulating the

heating and cooling equipment that delivers conditioned

air to that space. In addition to standard heating and

cooling control, they provide advanced control options

making them a state-of-the-art commercial building

control solution. The control can be done as a stand-alone

operation, however, when implemented with network

communication capabilities, optimal functional benefits

are achieved. These additional features are available

through the connection to an LCBS Connect gateway

which will enable access to the Honeywell cloud.

SPECIFICATIONS

Electrical

Rated Voltage: 20-30 Vac; 50/60 Hz

Power Consumption:

100 VA for controller and all connected loads

Controller only Load: 5 VA maximum

External Sensors Power Output: 20 Vdc ±10% @ 75 mA

maximum

Environmental

Controller Operating & Storage Temperature Ambient

Rating:

Minimum: -40° F (-40° C); Maximum: 150° F (65.5° C)

Relative Humidity: 5% to 95% non-condensing

Wall Module Operating Temperature: 32°F to 122°F

(0°C to 50°C)

Wall Module Storage Temperature: -4°F to 150°F (20°C

to 65°C)

Relative Humidity: 5% to 95%, Non-condensing

Controller Real Time Clock

Operating Range: 24 hour, 365 day, multi-year calendar

including day of week and configuration for automatic

daylight savings time adjustment to occur at 2:00 a.m.

local time on configured start and stop dates

Power Failure Backup: 24 hours at 32 to 100° F (0 to 38°

C), 22 hours at 100 to 122° F (38 to 50° C)

Accuracy: ±1 minute per month at 77° F (25° C)

Wall Module Accuracy

Temperature: ±0.36° F at 77° F (±0.2° C at 25° C)

Humidity: ±3% RH from 20–80%RH

Approval Bodies

UL/cUL (E87741) listed under UL916 (Standard for Open

Energy Management Equipment) with plenum rating.

CSA (LR95329-3) listed.

Meets FCC Part 15, Subpart B, Class B (radiated

emissions) requirements.

Summary of content (4 pages)

PAGE 1
LCBS Connect Controller and Wall Module SPECIFICATION DATA SPECIFICATIONS Electrical Rated Voltage: 20-30 Vac; 50/60 Hz Power Consumption: 100 VA for controller and all connected loads Controller only Load: 5 VA maximum External Sensors Power Output: 20 Vdc ±10% @ 75 mA maximum Environmental Controller Operating & Storage Temperature Ambient Rating: Minimum: -40° F (-40° C); Maximum: 150° F (65.
PAGE 2
LCBS CONNECT CONTROLLER AND WALL MODULE Meets Canadian standard C108.8 (radiated emissions). EMC Directive: 2014/30/EU: Standards Applied: — IEC 61000-4-8:2009 — IEC 61000-4-11:2004 — EN 61000-6-1: 2007; EN 61000-6-3:2007/A1:2011; EN 61000-6-3:2007/A1:2011/AC: 2012 — EN 60730-2-9: 2010, EN 60730-2-14: 1997 + EN60730-2-14/A1: 2001. — In conjunction with EN 60730-2-9:2010 and in conjunction with EN 60730-2-14:1997 and amendments: EN 60730-1: 2000 + A1: 2004 + A16: 2007 + A2: 2008 -Annex H.26.
PAGE 3
LCBS CONNECT CONTROLLER AND WALL MODULE Communications Each controller uses an FTT transformer-coupled communications port. The controller’s Manchester encoded data is presented to other controllers and devices on the LONWORKS® Bus at 78 kilobits per second (kbs) via Echelon® communication protocol. The transformercoupled communications interface offers a much higher degree of common mode-noise rejection while assuring dc isolation.
PAGE 4
LCBS CONNECT CONTROLLER AND WALL MODULE By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any liability, cost, or damages, including attorneys’ fees, arising out of, or resulting from, any modification to the literature by you. Home and Building Technologies In the U.S.